7
It is recommended
when testing on ceilings
(inverted) and/or vertically,
that a safety line is
attached around the tester body to
a suitable solid xing point. This will
stop the tester falling and prevent
injury to personnel and/or damage
to test unit.
If no suitable xing point is available
then attach to safety harness on
personnel.
Adjusting the handle position (g 7)
Fig 7
The top part of the unit can be rotated if the handle or gauge becoming obstructed by the
unit legs or other objects.
This is achieved by loosening the three grub screws (a) on the body using the allen key
provided. Rotate the top until the handle and gauge are clear of obstacles and re-tighten
the screws.
To Next Page
Loading...
