H Y D R O P O O L I N D U S T R I E S
29
FILTER CYCLES
Once the system clock time has been correctly set, the
system will automatically activate P1 low speed to filter the
water for three hours twice each day. During the filter cycle,
the LCD will indicate FILTER 1 or FILTER 2.
FILTER 1
The system automatically activates P1 low to operate from
2:00am until 5:00am.
FILTER 2
The system automatically activates P1 low to operate from
2:00pm until 5:00pm.
If the system is in ‘Economy’ mode, the heater will operate
during the filter cycles only.
PROGRAMMING FILTER CYCLES
To change the preset filter cycles or the filter cycle duration:
Press Time of day will display
Then press SET TIME will appear
Then press SET START FILTER 1 will appear. At this point,
each time the program (*) pad is pressed, the filter start
time, and the filter stop time will be indicated on the LCD
screen.
When the filter start or filter stop times are displayed on
the LCD screen:
Press or to reset the times.
When the SET hEAT message is displayed
Press or to set the heater to ’on‘ or ’off‘.
In the ’on‘ position, the hot tub water will heat to the set
temperature during the filter cycles. In the ’off‘ position,
the heater, when in ECONOMY mode, will not be acivated
during the filter cycles.
After entering the filter set routine,
Press to proceed through the start and stop times for
both filter cycles.
Follow the same procedure to program the ‘Filter 2’ settings.
To exit the filter set routine,
Press and the LCD screen will return to the current
water temperature.
Note
To properly clean and maintain your hot tub water, filtering
time of at least six hours per day (total of both cycles) is
recommended.
PURGE CYCLE
If your hot tub is equipped with a second pump (P2) and/or
a blower, the system will automatically activate each for
30 seconds at the beginning of every filter cycle.
MODE FUNCTION
This pad is used to change hot tub operation to either
ECONOMY or STANDARD mode.
ECONOMY MODE
the hot tub will heat only during the filter cycles.
STANDARD MODE
the preset hot tub temperature will be maintained (the
system will automatically activate P1 low speed when the
control calls for heat).
This pad also resets the system in the rare instance of an
overheat (see TOPSIDE PANEL DISPLAY MESSAGES).
PROGRAM FUNCTION
This pad is used for setting clock time, programming
filter cycles, and for panel lock routines.
To Next Page
Loading...
