2.0 Operating & Maintenance
10 CC1092267A
2.6 Maintenance
Maintenance intervals are preset when the compressor is
supplied, more information is available in the unit's user
handbook.
It may be necessary to adjust maintenance intervals to
suit ambient conditions. For example, the air filter‘s level
of contamination depends on the compressor's intake
conditions.
The HYDROVANE Pro allows the operator to program
various maintenance intervals (see section 2.7).
If there is a maintenance interval at +200h (hours), the
compressor is not automatically shut down. The
MAINTENANCE DUE message appears on the display.
If you want the compressor to automatically shut down
when a maintenance interval is due, you have to set this
function.
Go to the [MAINTENANCE SCHED.] sub-menu. Go to
the last SHUTDOWN OFF menu item, press the key.
The OFF value starts to flash. By pressing the
key you
can change the value to ON, confirm by pressing the
key.
The compressor now automatically shuts down when the
-100h maintenance interval is displayed.
Once maintenance is complete the interval should be
reprogrammed back to 2000h. Confirm the maintenance
message using the
key.
2.7 Programming maintenance intervals
To program a maintenance interval, go to the
[MAINTENANCE SCHED.] sub-menu. Here you can
program the maintenance intervals for:
AIR FILTER IN 2000h
OIL FILTER IN 2000h
SEPARATOR IN 4000h
OIL CHANGE IN 4000h
Go to the menu item required and press the
key, the
value then starts to flash. Use the
or key to set the
value to an interval of 0….9999, confirm your entry with
the
key.
If you do not want the maintenance intervals to be
monitored, program the intervals to more than 9999
hours in the various menu items. ---- appears on the
display. The maintenance interval is then blocked.
Note
Values shown are examples only, those used in your unit
may be different.
2.8 Total/load hours counter
Press the + keys at the same time to reach the
main menu. Press the key, you are now in the
[MAINTENANCE SCHED.] sub-menu. Use the or
keys to go to the various menu items.
The total hours counter states the time for which your unit
has been in on-load and off-load.
The load hours counter states the time for which your unit
has been in on-load.
Note
The total and load hours are lost if the HYDROVANE Pro
is replaced.
To Next Page
Loading...