Attention: Important for RS compressors
Risk of electric shock from charged capacitors!
Always disconnect the system from the power supply
and then wait a further 10 minutes before touching
electrical components. The power capacitors take this
time to discharge.
Check the DC bus voltage at the system terminal strip
of the inverter by measuring between the +DC and -DC
terminals and the chassis. The exact position can be
found in the operating manual of the inverter, the
voltage must read zero for all three measurements.
Controller Ref: CC1054325 Single Speed (SS)
Software version HPro-V1.02
Controller Ref: CC1068566 Regulated Speed (RS)
Software version HPro-RS-V1.04
Hydrovane adopt a policy of continual product
development. The information in this handbook, whilst
fully up to date when issued, may be subject to change
without notice.
To Next Page
Loading...