Hyena TREK FX+ - Introduction to the Assist System; Important Safety Notices and Warnings; General Safety Precautions for E-bikes

EN-GB - 2HYENA E-BIKE SYSTEMS
1. Introduction
Thank you for choosing your new e-bike with the Hyena riding assist system.
We sincerely hope that you will enjoy your ride.
This owner’s manual is intended for the user to operate the product and contains details of
the assist system.
1.1. Important notices
⚠
WARNING
Please carefully read all of the safety warnings and instructions throughout the manual.
Failure to follow these warnings and instructions could result in severe injury or death.
• Users who are not professionally trained for bicycle assembly should not attempt to install,
disassemble or modify components.
• If you have any concerns about the operation of the assist system or its components, or
if you suspect damage to the battery, visit your local authorised retailer immediately for
an inspection.
• The term ‘battery’ in this manual also applies to the (optional) range extender battery and
can in some cases apply to both batteries with the range extender installed on the e-bike.
► About Warnings Symbols
As you read this manual, you will see grey warning boxes like this:
⚠
WARNING
Text in a grey box with the safety alert symbol will warn you about a situation or behaviour
that could cause severe injury or death.
► About Images
The e-bike shown in this manual may di󰀨er visually from
your
Hyena-equipped e-bike.
All information provided in this manual is still applicable to your e-bike.
1.2. Safety instructions
Instructions Pertaining to a Risk of Fire, Electric Shock or Injury to Persons
⚠
WARNINGS
When using e-bikes powered by the Hyena assist system, basic precautions should always
be followed, including the following:
• To reduce the risk of injury, close supervision is necessary when the e-bike is used near
children.
• Do not put ngers or hands into any e-bike component or touch the connector terminals
with bare hands.
• Do not use the e-bike if any exible power cord or output cable is frayed, has worn insulation
or shows any other signs of damage.
• Always check the charger, cables and power cord for any damage before charging the
battery.
• Only charge the battery using an original Hyena charger.
• Do not immerse the e-bike or any e-bike component in water.