EN-GB - 3HYENA E-BIKE SYSTEMS
⚠
WARNINGS,
continued
.
• Do not place the e-bike or any assist system component (like the charger) near hot or
ammable objects or materials.
• The assist system parts are not intended to be used at ambient temperatures lower than
-10°C (14°F) or over temperatures of 45°C (113°F).
• Use only genuine Hyena replacement parts. If you use anything other than genuine Hyena
replacement parts, you may compromise the safety, performance or warranty of your e-bike.
• Do not modify your assist system to increase the power or maximum speed of your assist
system.
1.3. Riding safety
• Make sure you are familiar with your new e-bike before riding it on roads with multiple
vehicle lanes and pedestrian footpaths.
• Do not start on the fastest setting right away. Start on the low assist setting for your rst
few rides.
• Do not focus on the console while riding. A distracted rider increases the risk of being
involved in an accident.
• Riding with the assist system turned o is like riding a normal, non-electric powered bicycle.
• The assist system is designed to provide riding support up to the speed limits in compliance
with local regulations (e.g. 25 km/h in the EU region and Australia, 32 km/h in New Zealand
and 20 mph in the USA/Canada region). Do not modify your assist system or t any other
equipment to increase the power or maximum speed of your assist system, this will render
the bike illegal and void the warranty.
⚠
WARNINGS
• When the assist system is switched on and an assist level is selected, the riding support
is activated as soon as you start pedalling. You should be seated on the e-bike and
engage at least one brake before starting to pedal.
• With the assist system switched on, do not put one foot on a pedal and throw the other
leg over the bicycle, as the e-bike could accelerate unexpectedly.
Failure to follow this warning may result in serious injury or death.
To Next Page
Loading...