Hypertherm HyPerformance HPR400XD Auto Gas

OperatiOn
4-2 HPR400XD Auto Gas – 806160
How to optimize cut quality ..................................................................................................................................................................4-22
Tips for table and torch ............................................................................................................................................................... 4-22
Plasma set-up tips........................................................................................................................................................................4-22
Maximize the life of consumable parts ..................................................................................................................................... 4-22
Additional factors of cut quality .................................................................................................................................................4-23
Additional improvements ............................................................................................................................................................4-25
Cut charts ................................................................................................................................................................................................. 4-26
Thin stainless steel with HDi technology ...........................................................................................................................................4-26
Overview .........................................................................................................................................................................................4-26
Thick stainless steel piercing technique ............................................................................................................................................4-27
Overview .........................................................................................................................................................................................4-27
Fine Feature cutting ................................................................................................................................................................................4-29
Overview .........................................................................................................................................................................................4-29
Bevel cutting ............................................................................................................................................................................................4-30
Consumables ................................................................................................................................................................................4-30
Bevel compensation tables ........................................................................................................................................................ 4-30
Bevel cutting definitions ..............................................................................................................................................................4-31
Underwater cut charts ...........................................................................................................................................................................4-32
Overview .........................................................................................................................................................................................4-32
Estimated kerf-width compensation ................................................................................................................................................... 4-34