M
AINTENANCE
/P
ARTS
5-7
Operator Manual
Problem Cause/Solution
8. TORCH CAP LED illuminated; READY LED
extinguished.
9. OVER-TEMP LED illuminated; READY LED
extinguished.
10. Fan not running; POWER ON and READY
LEDs illuminated.
11. PRESSURE, TORCH CAP and OVER-TEMP
LEDs not working.
7.3 Refer to Service Manual IM-292 (802920) for
more detailed troubleshooting.
8.1 Check torch retaining cap to ensure it is tight.
8.2 Refer to Service Manual IM-292 (802920) for
more detailed troubleshooting.
9.1 Thermostat in power supply is open
(overheating). Allow the fan to run; the
thermostat closes when the unit has cooled
(see Section 4, Duty Cycle and
Overheating).
9.2 Refer to Service Manual IM-292 (802920) for
more detailed troubleshooting.
10.1 Refer to Service Manual IM-292 (802920) for
more detailed troubleshooting.
11.1 Refer to Service Manual IM-292 (802920) for
more detailed troubleshooting.
To Next Page
Loading...
