Hypertherm powermax 380 - Voltage Selector, Power Cord, and Grounding

SETUP
powermax380
Operator Manual 3-3
0


Input Voltage Selector Switch
The input voltage selector switch allows either 115V or 230V to be used as the Powermax380 input voltage. Set
the required voltage as shown below:
230 V, 1 PH
120 V, 1 PH
or
Voltage
selector
switch

1. Turn power OFF
2. Remove power cord
from power receptacle.
3. Set input voltage
• Determine correct switch
position for the voltage required.
• Voltage selector switch is
accessible through slot in rear
panel.
OFF
0
140140
5050
100100
ON
OFF
CAUTION
Do not reposition Voltage Selector Switch with power ON.
Damage to the power supply will result.