OPERATION
4-8 powermax30 Operator Manual
To start a cut from the edge of the workpiece
1. With the work clamp attached to the
workpiece, hold the torch nozzle
perpendicular to the edge of the
workpiece.
2. Press the torch trigger to start the arc.
Pause at the edge until the arc has cut
completely through the workpiece.
3. Drag the nozzle lightly across the
workpiece to proceed with the cut.
PMX30_OM_04.qxp:PMX30_OM_04 10/7/09 12:45 PM Page 4-8
To Next Page
Loading...
