MAINTENANCE AND PARTS
5-10 powermax30 Operator Manual
5. There are snaps on either side of each
endcap that hold the endcaps in place.
Insert needlenose pliers into the
opening for one of the snaps and use
the pliers to squeeze it together.
6. Place a flat-head screwdriver against
the raised rib next to the snap and
gently turn the screwdriver to push the
endcap away from the base.
7. Place another screwdriver or similar
object into the opening between the
endcap and the base to keep the first
corner of the endcap from returning to
its original position when you release
the other corner.
8. Repeat steps 5 and 6 on the other
corner of the endcap.
PMX30_OM_05.qxp:PMX30_OM_05 10/7/09 12:46 PM Page 5-10
To Next Page
Loading...
Need help?
General
