Hyster E40XMS - Page 17

2200 SRM 514 Cluster-Type Display Panel (Internal Combustion) Replacement
NOTE: Newer instrument clusters are non-re-
pairable and must be replaced with a new unit. If
the ignition switch fails, it is replaceable and can be
installed without replacing the instrument cluster.
4. Remove screws that hold cover to housing. For
older instrument clusters, replace parts in clus-
ter as necessary. Parts in cluster cannot be re-
paired.
1. WIRING HARNESS (24-PIN CONNECTOR)
2. WIRING HARNESS (6-PIN CONNECTOR)
3. GROUND WIRE RING TERMINAL
4. MOUNTING SCREWS
5. INSTRUMENT CLUSTER
6. STEERING COLUMN
Figure 6. Instrument Cluster Mounting (Newer
Model Cluster Panels)
Legend for Figure 6 (Continued)
24-PIN CONNECTOR FUNCTIONS
1
Malfunction Indicator (GM Gas Only)
2
Cluster Ground
3
Diesel Fuel Filter
4
Low Brake Fluid Level
5
Low Fuel Level (LPG)
6
Glow Plug
7
Engine Oil Pressure
8
Transmission Oil Temperature
9
AirFilterRestriction
10
Low Coolant Level
11
Charging Circuit
12
Left Turn Signal
13
Engine Oil Pressure Gauge
14
Right Turn Signal
15
Fuel Gauge
16
Coolant Temperature
17
Not Used
18
Not Used
19
Reversed
20
Forward
21
Not Used
22
Not Used
23
Parking Brake
24
Seat Switch
6-PIN CONNECTOR FUNCTIONS
1
Ignition
2
Accessory
3
Not Used
4
Starter
5
Battery
6
Battery
13