2200 SRM 514 Cluster-Type Display Panel (Internal Combustion) Replacement
Legend for Figure 7
1. COVER
2. FOAM GASKET
3. BULB
4. CIRCUIT BOARD
5. INDICATOR STRIP
6. BULB HOUSING
7. GASKET
8. HOURMETER
9. ENGINE OIL PRESSURE GAUGE
10. VOLTMETER
11. CIRCUIT BOARD
(RIGHT-HAND)
12. FUEL GAUGE
13. WATER TEMPERATURE GAUGE
14. CIRCUIT BOARD (
LEFT-HAND)
15. ALARM
16. SEAL
17. HOUSING
18. SCREW
19. KEY SWITCH
ASSEMBLE AND IN
STALL
NOTE: Newer ins
trument clusters are non-re-
pairable and mu
st be replaced with a new unit. If
the ignition sw
itch fails, it is replaceable and can be
installed with
out replacing the instrument cluster.
1. Install parts i
n instrument cluster that were re-
moved or replac
ed as shown in Figure 7. Make
sure seal is in
stalled between housing and cover.
2. Install instr
ument cluster on steering housing.
Install and ti
ghtenfourcapscrews. Onolder
model cluster
panels, connect the two wiring
harnesses at
the instrument cluster. See Fig-
ure 5 and Figu
re 8. For newer model cluster
panels, connec
t the 24-pin and 6-pin pig tail
connections an
d the ground wire to the steering
column. See Fig
ure 6 and Figure 8.
3. Install steeri
ng control unit and cover as de-
scribed in the f
ollowing sections:
•Steering Housi
ng and Control Unit 1600
SRM 512 for S/H2
.00-3.20XM (S/H40-65XM)
•Steering Housi
ng and Control Unit 1600
SRM 720 for S/H
1.25-1.75XM, S/H2.00XMS
(S/H25-35XM,
S/H40XMS)
4. Connect batte
ry. Check that gauges and indica-
tors operate a
s described.
15
To Next Page
Loading...
