Hytera PD375 - Setting the Radio

12
Features and Operations
●
When activities are detected on a channel, the radio will stay on the
channel to receive current activities, and the LED indicator will glow
green.
If the radio stays on a non-priority channel, the radio will display the
icon
. If the radio stays on Priority Channel 1 or Priority Channel 2,
it will display the icon
or respectively.
●
If you want to continue listening to the activities on the channel, press
the programmed
Monitor
or
Squelch Off Momentary
key during
scan stay.
●
If you want to stop scanning, go to “Menu -> Scan -> Scan On/Off”
and select “Off”, or press the programmed
Scan
key again.
The radio cannot scan analog channel and digital
channel at the same time.
Setting the Radio
You can opti mize per forma nce of your rad i o via the fol l owin g
conguration according to your actual needs and preferences by going to
“Settings -> Radio Settings”.
Talk Around
You can continue to communicate in DMO by pressing the programmed
Talk Around key
when the repeater malfunctions, or when the radio is
out of the repeater’s coverage but still within the coverage of the other
radio.
Note
You can enable and disable this feature via the “Settings” menu or by
pressing the programmed
Talk Around
key.
Power Level
This feature allows you to set the TX power level to high or low. High
power can extend the signal coverage, enabling you to communicate
with farther radios. Generally, we recommend you to adopt low power for
battery saving.
Besides the menu, you can also toggle the power level by pressing the
programmed
Adjust Power Level
key in the home screen for radios with
display (or in the standby mode for radios without display). Visible alert (for
radios with display only):
High power is indicated by
and low power is indicated by .
Adjust Squelch Level
This feature allows you to adjust the squelch threshold required for the
radio to be unmuted.
Generally, the higher squelch level requires stronger signal. If the squelch
level is set to “Open”, the speaker will keep unmuted irrespective of
the decoding conditions.
Besides the menu, you can switch the level among “Tight”, “Normal”
and “Open” by pressing the programmed
Adjust Squelch Level
key.
Backlight
You can set the backlight. Activating the backlight can illuminate the