15
5. Before Use
5.1 Charge the Battery
Caution:
Make sure the radio is powered off during charging.
Use only the charger and battery specified by Hytera. Charger LED can indicate the charging process.
See the table below. The following figure shows the steps for charging.
Step 1 Connect the power adapter to AC socket. See arrow ①.
Step 2 Plug the other end of the power adapter into the rear jack of the charger. See arrow ②.
Step 3 Place the radio with the battery attached, or the battery alone, into the charger. See arrow ③.
During charging, the LED on the charger will indicate the charging status. The charging status begins
when the charger LED glows red. When charging is complete, the charger LED glows green.
See the following table for details.
Note
To achieve optimal battery performance, please charge the battery for 5 hours before initial use.
Be sure to read the Safety Information Booklet to get necessary battery safety information.
LED Indication Charging Status
To Next Page
Loading...
