22
8. Functions and Operations
8.1 Rent
You can rent the radio from your dealer. When the rental period expires, you are not allowed to use this
radio.
If you rent this radio, please obtain the rental time information from your dealer. If the Rent Pre-Alert
feature is enabled, the radio will give a tone periodically to remind you the remaining time of your rental.
8.2 Scan
With the Scan feature, you can listen to communication activities on other channels so that you can keep
a close track of your team members.
Operation:
Step 1 To enable the feature, press the programmed Scan key in standby mode (a high-pitched tone
sounds); or switch to a channel for which the Auto Scan feature is enabled. When you switch to
the channel, the radio will start scan automatically.
Step 2 After the feature is enabled, the radio will scan according to the scan list set for the channel.
The scanning process is as follows:
During scanning, the LED flashes orange.
When activities are detected on a channel, the radio will stay on the channel to receive
current activities, and the LED will glow green.
If you don’t want to hear the activities on the channel, press the programmed Nuisance
Temporary Delete key to remove the channel from the scan list temporarily.
If you want to continue listening to the activities on the channel, press the programmed
Monitor key or Squelch Off key during scan stay.
To exit the scanning process, press the programmed Scan key again (a low-pitched tone
sounds).
8.3 Roam ▼
This feature allows the radio to communicate between sites in the same IP Multi-site Connect system.
After the feature enabled, the radio can communicate via any site in the IP Multi-site Connect system,
thus ensuring seamless communication in the system.
Operation: You can enable or disable the Roam feature by pressing the programmed Roam key.
To Next Page
Loading...
