Hytera PD602 - Emergency Mode; Operation Methods for Analog Emergency

29
8.21.3 Emergency Mode
Except “Siren Only”, other emergency types support the following three Emergency modes. You can
select one of them via your dealer (For the following operation methods, we take the “Regular” type as
an example).
Emergency
Mode
Description
Alarm In this mode, you can send alarm information to your companion or control center
by pressing the programmed Emergency On key, but you cannot talk with them.
Alarm with Call In this mode, you can send alarm information by pressing the programmed
Emergency On key. You can hold the PTT key to speak into the microphone. Your
voice and background noise to be transmitted.
Note:
If the Alarm with Call To Follow feature is enabled by your dealer, you
can speak into the microphone without holding the PTT key.
Emergency
Call
In this mode, press the programmed Emergency On key to go to the Revert
Channel, and you can hold the PTT key to speak into the microphone. Your voice
and background noise will be transmitted.
Note:
If the Alarm with Call To Follow feature is enabled by your dealer, you
can speak into the microphone without holding the PTT key.
This mode will be unavailable when the None or 5-Tone Emergency ID is sent.
8.21.4 Operation Methods for Analog Emergency
Alarm (None, 5-Tone & HDC1200)
Initiating an emergency alarm:
Press the programmed Emergency On key send the emergency information, and the LED glows red.
Note:
As for None and 5-Tone emergency alarms, if “Local Emergency Alarm” is enabled via the
programming software, the radio will give an alarm tone.
Exiting the emergency alarm:
The emergency alarm initiator exits the Emergency mode in any of the following ways:
 Press the programmed Emergency Off key.
 Turn off the radio.
 Once the emergency cycles expire, the radio will exit the Emergency mode automatically.