Hytera PD602 - Appendix; Signaling Introduction; HDC1200; 5-Tone

38
12. Appendix
12.1 Signaling Introduction
The radio supports the following signaling. You can ask your dealer to make appropriate settings on the
radio. For detailed information, please consult your dealer.
12.1.1 HDC1200
The HDC1200 signaling is compatible with the MDC1200 signaling, and realizes functions such as PTT
ID (Encoding & Decoding), Emergency (Encoding & Decoding) and Selective Call (Encoding &
Decoding).
Encoding
When initiating a normal call, hold the PTT key during normal voice communication to send PTT ID. For
encoding, the radio will provide the following indications:
 PTT ID/Selective Call: Your dealer can program whether the radio sounds side tone during encoding
or beeps after encoding.
 Selective Call: During encoding, the LED glows red. After encoding, the LED glows orange.
Decoding
For decoding, the radio provides the following indications:
 Selective Call: After decoding, the radio provides the following indications:
 Tone: The radio will give the tone by default.
 LED: The LED glows green.
12.1.2 5-Tone
The radio can realize various types of calls through 5-Tone signaling.
Encoding
Step 1 Request your dealer to configure the correct format and type for the encoding contents.
Step 2 When the format consists of fixed codes only, you do not have to edit such fields or save such
data.
Step 3 Hold the PTT key or press the programmed One Touch Call key to send the 2-Tone signaling.
During encoding, the LED glows red and the Side tone will be given. If Auto Reset is enabled
(by your dealer), the radio will enter the Auto Reset mode after successful encoding, with the
LED glowing orange, until the Auto Reset Time expires.