17
unlock the battery.
5.2.3 Assembling the Belt Clip
Step 1 Remove the screws on the back of the radio, as shown in the following figure.
Step 2 Align the screw holes in the belt clip and on the radio’s back, and then tighten the screws.
To remove the belt clip, loosen the screws.
5.2.4 Attaching Audio/Programming Cable
Step 1 Open the accessory jack cover as the arrow below shows.
Step 2 Align the accessory connector with the accessory jack.
Caution
When aligning, make sure not to scrape the silica gel surrounding the accessory jack
screw hole, in order to ensure the waterproof performance of the radio.
Be sure to align the screw on the accessory connector to the screw hole in the jack
before fastening the screw.
Step 3 Tighten the screw on the connector.
To remove the accessory connector, loosen the screw.
To Next Page
Loading...
