Hytera PD602 - Man Down; Lone Worker; Priority Interrupt; Manual Priority Interrupt

26
8.17 Man Down ▼
This feature is enabled by your dealer via the programming software. With the feature enabled, the radio
will give an alert tone if it tilts to a certain gradient (defined by the dealer) or stay motionless until the
preset period (10s by default) expires. If you fail to place the radio upright or move it during the tone
lasting time, it will enter the Emergency mode automatically. To exit the Emergency mode, move the
radio or place it upright.
Operation: You can enable/disable this feature by pressing the programmed Man Down key. The radio
gives a high-pitched tone when the Man Down feature is enabled and a low-pitched tone when the
feature is disabled.
8.18 Lone Worker
This feature is ideal for persons who work alone. If you encounter an incident and cannot operate your
radio within the preset time period, your radio will alarm automatically to summon help from your
companion.
Operation: Press the programmed Lone Worker key (a high-pitched tone sounds) to enable the feature
quickly or just turn on the radio if the feature is enabled via the programming software. Press the
programmed Lone Worker key again to disable the feature (a low-pitched tone sounds).
If you do not operate the radio within a preset response period, it will give alerts before this period
expires (dependent on the settings by your dealer). Now you can terminate the alerts by rotating a knob
or pressing a key. When the response period expires, the radio will trigger the emergency on the current
channel automatically.
Note: If the Lone Worker feature is not disabled before your radio is powered off, it will remain
enabled when the radio is powered on again.
8.19 Priority Interrupt
8.19.1
Manual Priority Interrupt
You can have the priority interruption by pressing the programmed Priority Interrupt key. By pressing
this key, you can terminate the ongoing activity (a call, Call Hold Time or remote monitoring) on the
current channel, so as to initiate a new call or data service.
Call Hold Time: the duration the radio stays at in-call status after the end of the call. The Call Hold Time
includes two types: Group Call Hold Time and Private Call Hold Time. Within the time, you can hold the
PTT key to directly call back.