33
9. Troubleshooting
Phenomena Analysis Solution
Power-on failure
The battery may be
improperly installed.
Remove the battery and attach it again.
The battery may run out. Recharge or replace the battery.
The battery may suffer from
poor contact caused by
dirtied or damaged battery
contacts.
Clean the battery contacts. If the problem can
not be solved, contact your dealer or authorized
service center for inspection and repair.
During receiving,
the voice is weak,
discontinuous or
totally inactive.
The battery power may be
too low.
Recharge or replace the battery.
The volume may be set to a
low level.
Increase the volume.
The antenna may get loose
or improperly installed.
Power off the radio, and re-install the antenna.
The speaker may be blocked
or damaged.
Clean surface of the speaker. If the problem can
not be solved, contact your dealer or authorized
service center for inspection and repair.
You can not
communicate with
other members.
The frequency or signaling
may be inconsistent with that
of other members.
Set your TX/RX frequency and signaling to the
same as that of other members.
The channel type
(digital/analog) may be set
inconsistently.
Make sure all members are on the same
digital/analog channel.
You may be too far away
from the group members.
Move towards other members.
Irrelevant
communication or
noise is heard on
You may be interrupted by
radios using the same
frequency.
Change the frequency, or adjust the squelch
level.
To Next Page
Loading...
