32
Step 2 When the LED glows red, you can hold the PTT key and speak into the microphone to make an
emergency call.
Note:
If the Alarm with Call To Follow feature is enabled by your dealer, you can speak into the
microphone without holding the PTT key. If the preset Voice Cycles expire, you can hold the PTT
key to make the emergency call again.
Step 3 When the LED flashes orange quickly, you can receive. And when a call is received, the LED
glows green.
Step 4 If the preset Voice Cycles expire, you can press the PTT key to make the emergency call again
(the LED glows red). Release the PTT key to receive (the LED flashes orange quickly); when a
call is received, the LED glows green solidly.
Exiting the emergency alarm:
To exit the Emergency mode, press the programmed Emergency Off key or power off the radio.
When an alarm is received, the receiving party can exit the emergency alert by pressing the TK key
within 2s after pressing the Back key, or switching the channel or powering off the radio.
Emergency Call
Initiating an emergency alarm:
Step 1 Press the programmed Emergency key to go to the Revert Channel.
Step 2 If the feature “Alarm with Call to Follow” is enabled, you can speak into the microphone to make
an emergency call when the LED glows red.
Step 3 When the LED flashes orange, your radio can receive call.
Step 4 If the preset Voice Cycles expire, you can hold the PTT key to make the emergency call again
(the LED glows red). After the emergency call is transmitted, please release the PTT key to
receive.
Exiting the emergency alarm:
To exit the Emergency mode, press the programmed Emergency Off key or power off the radio.
The emergency receiving party cannot exit the emergency alarm manually. When the initiator exits the
alarm, the receiving radio will exit automatically.
Note: Your dealer may set the number of polite retries and impolite retries, number of voice cycles,
duration of each transmission and TX interval.
To Next Page
Loading...
