30
Hold the PTT key to exit the Emergency mode. The radio will transmit the voice on the channel where
the radio operates before entering the Emergency mode (for HDC1200 only).
The emergency alarm receiving party exits the emergency alarm in any of the following ways:
None: When the alarm is received, the receiving party can press any key to exit the emergency alert.
When the alarm initiator exits the Emergency mode or when the Alarm Cycles expire, the receiving
radio will exit the emergency alert automatically.
5-Tone: When an alarm is received, the receiving party can press any key to exit the emergency alert.
HDC1200: When an alarm is received, the receiving party can exit the emergency alert by pressing
the TK key within 2s after pressing the Back key, or switching the channel or powering off the radio.
Alarm with Call (None, 5-Tone & HDC1200)
Initiating an emergency alarm:
Step 1 Press the programmed Emergency On key to send the emergency information, and the LED
glows red.
Note:
As for None and 5-Tone emergency alarms, if “Local Emergency Alarm” is enabled via
the programming software, the radio will give an alarm tone.
Step 2 If the “Alarm with Call To Follow” feature is enabled, when the alarm tone disappears (None or
5-Tone) or after the Emergency ID is sent (HDC1200), you can speak into the microphone to
make an emergency call.
Step 3 If the preset Voice Cycles expire, you can hold the PTT key to make the emergency call again
(the LED glows red). After the emergency call is transmitted, release the PTT key to receive (the
LED will flash orange rapidly) (for HDC1200 only).
Exiting the emergency alarm:
The emergency alarm initiator exits the Emergency mode in any of the following ways:
Press the programmed Emergency Off key.
Turn off the radio.
After the preset Alarm Cycles and Voice Cycles expire, the radio will exit the Emergency mode
automatically (for None and 5-Tone only).
The emergency alarm receiving party exits the emergency alarm in any of the following ways:
None: When the alarm is received, the receiving party can press any key to exit the emergency alert.
When the alarm initiator exits the Emergency mode or when the Alarm Cycles expire, the receiving
radio will exit the emergency alert automatically.
5-Tone: When an alarm is received, the receiving party can press any key to exit the emergency alert.
To Next Page
Loading...
