8
Duplexer Mounted with Front Side Facing Downwards
Installation
Electrical Connections
After the repeater has been mechanically installed,
electrical connections must be made. This involves making
the following connections:
DC power cord
Antenna cables
See the rear panel view for the positions of connectors.
Power Supply Connections
1. Ground Connection
The repeater is equipped with a ground screw located on
the rear panel. Connect ground wires to the screw.
2. DC Power Supply or Battery Backup Connection
The repeater may be connected to a regulated DC power
supply or a backup battery.
The DC source or battery backup system is connected to
the repeater through the DC power inlet at the rear of the
repeater (see rear panel view).
●
●
To Next Page
Loading...
