Figure 31
7 FAQ
1) Can I use any adaptor with my iBaby monitor? No, an unmatched power adapter
can severely damage the equipment.
2) Why is my browser slow when I look at video from my camera? That may occur if
your Web connection isn't fast enough to support the MJEPG video compression used
by the iBaby monitor. The typical bandwidth uses situation as below:
640x480@10fps : 4.0 Megabits ～ 5.0 Megabits
320x240@30fps : 1.2 Megabits ～ 1.6 Megabits
3) I can’t find my iBaby monitor after I have connected it to a LAN
Make sure the monitor and your PC are on the same LAN. Make sure your firewall is not
blocking signals from the device.
4) I can see my camera listed, but I can't access it. Make sure both the camera and the
PC have the same Network Segment in their IP address. (This is the first three numbers
of the address.) If the IP address of your PC, for example, is 192.168.0.100, it can only
access equipment with IP addresses between 192.168.0.1 and 192.168.0.255.
5) I can access the monitor via its public IP address, but I can’t visit it via the
manufacturer’s domain name
Make sure the DNS settings are the same as on your PC.
To Next Page
Loading...
