BIOS SETUP
28
IB891 User’s Manual
Power Management/APM
By default, this field is set to Enabled.
Power Button Mode
Go into On/Off, or Suspend when power button is pressed.
Resume on Ring
This option is used to enable activity on the RI (ring in) modem line to wake up
the system from a suspend or standby state. That is, the system will be awakened
by an incoming call on a modem.
Resume on PME#
This option is used enable activity on the PCI PME (power managementevent)
controller to wake up the system from a suspend or standby state
Resume On RTC Alarm
This option is used to specify the time the system should be awakened from a
suspended state
To Next Page
Loading...
