IBASE Technology IB891 - System Security and Password Settings

BIOS SETUP
IB891 User’s Manual 33
Security Settings
This setting comes with two options set the system password. Supervisor
Password sets a password that will be used to protect the system and Setup
utility. User Password sets a password that will be used exclusively on the
system. To specify a password, highlight the type you want and press <Enter>.
The Enter Password: message prompts on the screen. Type the password and
press <Enter>. The system confirms your password by asking you to type it
again. After setting a password, the screen automatically returns to the main
screen.
To disable a password, just press the <Enter> key when you are prompted to
enter the password. A message will confirm the password to be disabled. Once
the password is disabled, the system will boot and you can enter Setup freely.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Security Settings
Install or Change the
Password.
<- Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Boot Sector Virus Protection [Disabled]