Contents
Safety ............................iii
Chapter 1. Introduction ......................1
The IBM Documentation CD ....................2
Hardware and software requirements ................2
Using the Documentation Browser .................2
Specifications ..........................4
Internal circuit configuration.....................5
Notices and statements in this document................6
Chapter 2. Installing the uninterruptible power supply .........7
Inventory checklist ........................7
Front view of the UPS.......................8
Rear view of the UPS .......................9
Front view of the extended battery module ...............9
Rear view of the extended battery module ...............10
Rack installation ........................10
Connecting an extended battery module to the UPS ...........11
Completing the installation.....................13
Installing the remote emergency power-off ...............14
Hard-wiring the UPS input (for licensed electrician only) ..........16
Connecting the UPS internal batteries ................19
Disconnecting the UPS internal batteries ...............22
UPS initial startup ........................25
Chapter 3. Operating the uninterruptible power supply .........27
Control panel .........................27
Operating modes ........................28
Normal mode ........................28
High Efficiency mode .....................28
Converter mode .......................29
Battery mode ........................29
Bypass mode ........................29
Standby mode ........................29
Turning on the UPS .......................29
Starting the UPS on battery ....................29
Turning off the UPS .......................29
Display functions ........................30
System status ........................30
Alarm history ........................30
Meters ...........................31
Control screens........................31
Model information .......................32
Configuration ........................32
Transferring the UPS between modes ................35
Transferring from Normal to Bypass Mode ..............35
Transferring from Bypass to Normal Mode ..............35
Setting the power strategy.....................36
Retrieving the alarm history ....................37
Behavior on overload ......................37
Configuring load segments ....................38
Controlling load segments through the display ............38
Configuring automatic start delay .................39
© Copyright IBM Corp. 2011 ix
To Next Page
Loading...
Need help?
General
