Configuring load segments
Load segments are sets of receptacles that can be controlled through the LCD, by
the network management card, or by power-management software, providing an
orderly shutdown and startup of the connected devices. For example, during a
power outage, you can keep key devices running while you turn off other devices.
This feature enables you to save battery power. For more information, see your
power-management software documentation.
The UPS has two load segments that are shown as shaded areas in the following
illustration. The shading does not appear on the chassis.
Controlling load segments through the display
To control the load segments through the display, complete the following steps:
1. From the main menu, press the down ( ) button to scroll to the Control menu,
and press the OK button.
2. Press the down (
) button to scroll to Load Segments, and press the OK
button.
3. Press the down (
) button to scroll to the load segment that you want and
press the OK button.
4. Press the down (
) button to set the selected load segment to On or Off.
5. Press the OK button for 1 second to confirm.
6. Repeat step 3 to step 5 to set the other load segment, if applicable.
38 11000 VA UPS and 11000 VA EBM: Installation and Maintenance Guide
To Next Page
Loading...
Need help?
General
