Need help?Do you have a question about the IBM 2145UPS-1U and is the answer not in the manual?
General| Category | UPS |
|---|---|
| Output Power Capacity | 1500 VA / 1350 W |
| Battery Type | Sealed Lead-Acid (SLA) |
| Warranty | 2 years |
| Form Factor | Rack-mountable (1U) |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Typical Backup Time at Full Load | 5 minutes |
| Typical Recharge Time | 3 hours to 90% |
| Communication Interface | USB |
| Operating Temperature | 0 to 40°C (32 to 104°F) |
| Operating Humidity | 0% to 95% relative humidity (non-condensing) |
| Output Connections | 8 x IEC 320 C13 |
Highlights the importance of safety when using the SAN Volume Controller and related components.
Provides steps to check the SAN Volume Controller for potential safety hazards before installation.
Explains configuration, operation, and minimum requirements for the 2145 UPS-1U.
Lists steps to prepare for installation, including checking parts and planning.
Covers installation of the redundant ac power switch, UPS-1U, and the SAN Volume Controller node.
Provides information on using and installing the 2145 UPS and 2145 UPS-1U.
To Next Page
