IBM 4820 - Installing the VESA Bracket

Table 3-1. Cable types and icons (continued)
Type Identifying Icon Cable
Multi-connector cable for
model 42T
4
PS/2 keyboard connector
(for diagnostics)
RS-232 Touch
RS-232
(Touch/MSR/keypad)
RS-232 MSR
Host end 4820 end
Keypad /
Keyboard
Multi-connector cable for
model 4FT
RS-232 Touch
RS-232
(Touch/MSR)
RS-232 MSR
Host end 4820 end
The following is a list of cables that require routing through the free-standing pedestal of
the 4820 SurePoint Solution:
v Video
v Power
v Pointing device
Pedestal mounting
The 4820 SurePoint Solution models 42D, 42T, 4FT, and 4FD can be attached to a
free-standing pedestal. Optionally, you can mount the pedestal to the counter. A
mounting template is provided for installation of the pedestal (refer to Figure C-2 on
page C-2.) See “Mounting the distributed pedestal” on page A-1 for instructions.
Adjusting the display
This section summarizes the methods of adjusting the 4820 SurePoint Solution.
Brightness menu
Available when you press the minus or plus buttons.
OSD menu
The on-screen display menu appears when you press the minus and plus
buttons simultaneously. For additional information, see “Using the OSD menu”
on page 7-1.
4820 Video Quality Test Pattern
This file is available from the Web support site. Use this file when the Auto
Adjust menu item fails to produce satisfactory results.
4820 42T/4FD POS Terminal Service diskette
This diskette is available from the Web support site and allows you to calibrate
the touch and test the MSR.
3-2 4820 SurePoint Solution System Reference