twinax command interpreter
Multi–Platform Interface Feature Operation Guide 41
COMMAND ACTION
¬ONN Enable the command interpreter. Ignored if already
on.
¬OFF Disable the command interpreter - Default, power up
state. Ignored if already off.
¬HEX Pack valid Hexadecimal characters two to a byte and
send to the printer. Invalid Hexadecimal characters will
be skipped - all SNA commands will be passed out.
Terminate Hex mode by sending an at sign "@".
Table 6 Twinax Command Interpreter Commands
Commands
Preface each of the commands in the
following list with a single logical-not
character as shown in this document by the
"¬" character.
Table 6 Gives an explanation of all the
available commands.
To Next Page
Loading...
