IBM 6400 - Table 10 Coax Error Messages; Table 9 Twinax Error Messages

compatibility issues
Multi–Platform Interface Feature Operation Guide 55
Error Reported Cause
Unit Not Available Printer Offline
Unit Not Available, End of Forms Paper Error
Exception Status Codes
Invalid Activate
Invalid Command
Overrun
Power On Transition
Twinax Protocol Error
Twinax Protocol Error
Twinax Protocol Error
Power On Transition
Invalid SCS Control Code Invalid Control Code
Invalid SCS Parameter Invalid Parameter
Graphic Check Unprintable character detected
after receipt of a “set graphic
exception action”
Table 9 Twinax Error Messages
Error Reported Cause
Intervention Required Paper Out (if enabled, after
timeout)
Order Reject Invalid Order Detected
Invalid Parameter Invalid Parameter in SCS data
stream
Table 10 Coax Error Messages
Error Messages
The following tables show error messages
as reported to the host system and the
causes of those messages. These are the
only error messages the MPI reports to the
Twinax or Coax host.