diagnostics
Multi–Platform Interface Feature Operation Guide 51
Checklist
If the controller's built-in diagnostic tests do
not perform according to Table 7 (coax) on
page 49 and Table 8 (twinax) on page 50.
1 Run each diagnostic and save the
diagnostic printout.
2 Check all of the installation
connections.
3 Verify that the printer’s configuration is
set according to Table 3 on page 10.
When diagnostics are complete:
1 Power off the printer and wait 15
seconds
2 Set the address switch back to the
original position
3 Power on the printer and resume
normal operation
To Next Page
Loading...
