Multi–Platform Interface Feature Operation Guide 53
9 Verify that the Multi–Platform
Interface’s configuration switch settings
are correct (See Table 1 on page 6
(twinax) or See Table 2 on page 7
(coax)).
10 Put the MPI in coax or twinax code
dump mode and print the job in
hexadecimal format. Use this printout to
verify data from the host.
11 With the MPI not in code dump mode,
set the printer configuration to Hex Print
Mode and print the job. Use the printout
to verify the hexadecimal output of the
MPI going to the printer.
12 With no host cable attached, the LEDs
will light briefly (about 1 second) when
the MPI has completed initialization. If
the LEDs do not do this, the MPI's
power connection may be faulty.
To Next Page
Loading...
