64 Multi–Platform Interface Feature Operation Guide
Step2 – JES2 Definition (SYS1.PARMLIB)
RMT1 LUTYPE3,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,
NOCMPCT,SETUPHDR,CONSOLE
R1.PR1 CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,
F,T/C,P),CKTPAGE=30
DESTID NAME=LOC64XX,DEST=R1
Step 3 – Define to CICS or another
application program
Refer to the vendor documentation for
defining a DSE printer to the program for its
use. Host system commands to change
printer setting are not supported in DSE
mode.
Step 4 – Printer Settings
In LU3 mode the printer settings control the
CPI, LPI and all other aspects of the printed
output. Therefore, you must set the printer
settings to match the characteristics of the
job you are printing. Host controls are not
supported in this mode, except for the coax
Command Interpreter commands on page
19.
To Next Page
Loading...
Need help?
General