IBM 8863 - eServer xSeries 366 - Page 88

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, “Parts listing, Type 8863,” on page 93 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only)”, that step must be performed only by a
trained service technician.
Error code Description Action
180-xxx-001 Failed front LED panel test.
1. Reseat the following components:
a. (Trained service technician only) Operator
information panel
b. I/O board
c. Microprocessor tray
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. (Trained service technician only) Operator
information panel
b. I/O board
c. (Trained service technician only)
Microprocessor tray
180-xxx-002 Failed diagnostics LED panel test.
1. Reseat the following components:
a. (Trained service technician only) Operator
information panel
b. I/O board
c. Microprocessor tray
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. (Trained service technician only) Operator
information panel
b. I/O board
c. (Trained service technician only)
Microprocessor tray
180-xxx-005 Failed SCSI backplane LED test.
1. Reseat the following components:
a. SAS hard disk drive backplane cable
b. I/O board
c. Microprocessor tray
2.
Replace the following components one at a time,
in the order shown, restarting the server each
time.
a. SAS hard disk drive backplane cable
b. SAS hard disk drive backplane
c. I/O board
d. (Trained service technician only)
Microprocessor tray
72 IBM xSeries 366 Type 8863: Problem Determination and Service Guide