Figure 44. Removing the power supplies
1) Label the power cord, and then unstrap the hook-and-loop fastener (D) to release the power
cord (A) from the power supply handle. Retain the hook-and-loop fastener for future use.
2) Pull the power cord (A) out of the power supply (C) in the direction shown. Pull the power cord
connector; do not pull the cord itself.
3) To unseat the power supply from its position in the system, push the locking-tab (B) in the
direction shown.
4) Using the handle (E), pull the power supply (C) away from the system.
5) Repeat steps “2.b.i” on page 62 - “2.b.iv” on page 62 for each power supply.
c) Remove the side cover.
Refer to Figure 45 on page 63.
62
Power Systems: Common procedures for installable features
To Next Page
Loading...
