Check Procedures 2-41
NOTE:
If the screen shows a blinking cursor with no memory count running,
answer this question "No."
−
Select
Interactive Tests
from the Main Menu.
−
Select and execute
Video
test from the menu.
−
Follow the prompts and perform the video test.
−
Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-8.
NOTE:
You might have to adjust the monitor controls to obtain the best
image.
003 - DOES THE MONITOR SUCCESSFULLY PASS ALL TESTS? (YES,
READ AHEAD. NO, GO TO STEP 004)
−
You have successfully completed the video diagnostics tests. If the
problem remains, go to “Index of Symptoms, Messages, Error
Codes, or Beeps” on page 2-8.
−
End.
004 -
−
Power off the system unit.
−
Remove the hard disk drive system cable.
−
Power on the system unit.
005 - IS THE SCREEN READABLE?
−
Replace the monitor. If the symptom remains, replace the system
board.
−
End.
To Next Page
Loading...
Need help?
General
