General Information 1-21
Plug and Play OS
When this parameter is set to Yes, BIOS initializes only Plug and Play boot
devices, then the Plug and Play operating system takes care of the other
devices. When set to No, BIOS initializes all Plug and Play boot and non-boot
devices.
Set this parameter to Yes if you are using the Windows 98 operating system.
Set to No if you run any other operating system. The default setting is Yes.
Reset Resource Assignments
Set this parameter to Yes to avoid IRQ conflict when installing non-Plug and
Play cards.
Before you install non-Plug and Play cards, set this parameter to Yes, exit
Setup and turn off the computer. This clears all resource assignments and
allows BIOS to reassign resources to all installed Plug and Play devices the
next time the system boots. After clearing the resource data, the parameter
resets to the default setting No.
To Next Page
Loading...
