• Real-time digital thermometers for temperature monitoring.
• Real-time clock (RTC) with battery.
• Connectors:
– One 10/100/1000Mb/s RJ-45 Ethernet connector for the management connection. With
EZSwitchSetup, this port supports switch IP address discovery and conguration, eliminating the
need to attach a serial cable to congure the switch IP address.
– One RS-232 3-wire (Tx, Rx, and GND) universal asynchronous receiver/transmitter (UART) serial port
to the baseboard management controller (BMC) with an RJ-45 connector for debugging the initial
switch setup (if not using EZSwitchSetup) and factory default restoration. Integral LEDs remain unlit
always.
– One external USB Type A connector.
License options
The SAN128B-7 switch uses a capacity-based Ports on Demand (POD) license method. Refer to the
Brocade Fabric OS Software Licensing Guide for more details.
Port-side view
The following illustration shows the port-side view of the SAN128B-7 Fibre Channel switch.
Figure 1. Port-side view
1. System Power LED
2. System Status LED
3. USB Port
4. 48 SFP+ 64G FC Ports (FC Ports 0–47)
5. 8 DD 64G Ports (FC Ports 96–111)
6. 8 DD 64G Ports (FC Ports 112–127)
7. 48 SFP+ 64G FC Ports (FC Ports 48–95)
8. UART RJ-45 Serial Console Port
9. 10/100/1000Mb/s RJ-45 Ethernet Management Port
The following gure shows the port numbering for the SAN128B-7 Switch. Trunk groups are outlined in
red.
2
IBM Storage Networking SAN128B-7: SAN128B-7 Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General