What to do if IBM SAN42B-R has dust or dirt?
If you find dust, dirt, or other contaminants affecting your IBM Storage, you should re-seat the transceivers for the failing link. Additionally, clean the connector and optical fiber to ensure optimal performance.
How to resolve incompatible SFPs in IBM SAN42B-R Storage?
To resolve issues with incompatible SFPs in IBM Storage, use 4 Gbps LWL transceivers or use 8 Gbps LWL transceivers that employ rate select.
Details on danger, caution, and attention notices, and safety labels.
Guidelines for preventing electrostatic discharge damage.
Precautions for installing equipment in racks and cabinet safety.
Conditions required for correct installation and operation.
Procedures for installing the switch on a flat surface.
Instructions for installing the switch in a standard EIA cabinet.
Steps for mounting the switch flush with the front of the rack.
Steps for mounting the switch recessed in the rear of the rack.
Steps for configuring the switch for network and fabric operation.
Instructions on connecting power to the switch.
Steps to establish a serial connection for configuration.
Procedures for assigning an IP address to the switch.
How to assign a unique domain ID to the switch.
Guide to installing transceivers and connecting cables.
Steps to confirm proper function and save configuration.
How to understand the results of the Power-On Self-Test.
Information on using built-in diagnostic tests for troubleshooting.
Step-by-step guide to replacing power supply units.
Instructions for replacing fan modules in the switch.
Procedures for replacing the main chassis of the unit.
To Next Page
General