î1î - Screws, 10-32 x 5/8-in., panhead Phillips
î2î - Retainer nuts, 10-32
2. Attach the right front bracket to the right rear rack post using two 10-32 x
5/8-in. panhead screws (î1î) and two retainer nuts (î2î). Use the upper and
lower holes in the bracket.
3. Repeat step 2 to attach the other front bracket to the left rear rack post.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
Attaching the rear brackets to the extensions at the front of the
switch
Complete the following steps to attach the rear brackets to the extensions at the
front of the switch. There are short and long rear brackets you can use for this
step. Choose the correct bracket for the depth of your rack. See Figure 5 on page 11
for detailed illustrations of the parts.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket (î1î) onto the right extension, as shown in Figure 15
on page 20 (The short rear brackets are shown.) Use the first and third vertical
pairs of holes for the screws. See Figure 16 on page 20 for more detail of the
position of the short or long brackets and screws (long brackets shown).
b42r014
1
2
2
Figure 14. Positioning the switch flush to the rear of the rack
Chapter 2. Installing and configuring the switch 19
To Next Page
Loading...
Need help?
General