IBM System Storage TS3100 Installation Quick Reference Guide

4. Carefully return the library to an upright position.
Important: Do not stack objects on top of the library.
Removing and Storing the Shipping Lock
Important: The shipping lock, which prevents the library accessor from moving during shipment, must be
removed before the library is powered ON.
The shipping lock is held in place with a label and is located in the top center of the library. After the
shipping lock is removed, it should be stored on the right side of the back panel of the library for future
use.
To remove and store the shipping lock:
1. Remove the blue label (
2
) that is securing the lock (
1
) to the top of the library, then remove the
lock (see Figure 1-2 on page 1-4).
1
a77ug085
Figure 1-1. Installing foot pads on the bottom of the library chassis
Installation 1-3

IBM System Storage TS3100 Specifications

General

Number of Tape Drives	1
Number of Tape Cartridges	24
Product Type	Tape Library
Operating Humidity	20% to 80% non-condensing
Interface	SAS
Supported Tape Drive Types	LTO Ultrium 5, LTO Ultrium 6
Tape Drive Technology	LTO Ultrium