v Cancel - to delete your settings.
Entering Date and Time using the Operator Control Panel
1. Navigate to Configure ā Date and Time.
2. Use the UP and DOWN buttons to select Time.
3. Press the ENTER button to highlight the first time field.
4. Using the UP and DOWN buttons, enter each digit of the time (HHMM). After selecting each digit,
press ENTER to move to the next field.
5. After you have correctly entered the time, press ENTER to select Time.
6. Press the DOWN button to select Date.
7. Press the ENTER button to highlight the first date field.
8. Using the UP and DOWN buttons, enter each digit of the DATE (MMDDYYYY). After selecting each
digit, press ENTER to move to the next field.
9. After you have correctly entered the date, press ENTER to select Date.
10. Press the DOWN button to select SUBMIT.
11. Press ENTER to apply your changes.
Entering Control Path Failover License Activation Key using the Operator Control
Panel
1. Navigate to Configure ā Control Path Failover.
2. Press the ENTER button to highlight the first digit of the 12-digit license key.
3. Use the UP and DOWN buttons to select each digit.
4. Press the ENTER button to move to the next digit.
5. After entering the final digit, press the DOWN button and select one of the following:
v Save - to apply your settings.
v Cancel - to delete your settings.
Restoring Factory Default Settings using the Operator Control Panel
DO NOT USE THIS ITEM UNLESS YOU WOULD LIKE TO ERASE ALL LIBRARY SETTINGS AND
RESTORE FACTORY DEFAULT SETTINGS.
Cartridge Magazines
The library has removable magazines. Magazine access is password protected. For safety reasons, the
accessor motion is stopped when a magazine is removed.
The magazines can be released using the Operator Control Panel or the Web User Interface. In case the
Operator Control Panel or Web User Interface initiated process has failed or the library no longer has
power, a manual emergency release is available.
Important: To manually release a magazine, refer to the Setup, Operator, and Service Guide. This
manual process should only be used if the magazine cannot be released using the Operator
Control Panel or the Web User Interface.
2U Library Cartridge Magazines
The 2U library has two cartridge magazines. The left cartridge magazine (see Figure 1-27 on page 1-24)
has ten storage slots and houses the 1-slot I/O Station. The right magazine (see Figure 1-28 on page
1-24) has twelve storage slots. For information about Element Addressing, refer to the Setup, Operator,
and Service Guide.
Installation 1-23
To Next Page
Loading...
Need help?
General
