6. Insert the fan into the fan slot in the fan assembly bracket and press it down
until it is seated correctly in the slot and the fan connector is seated correctly in
the connector on the system board.
Note: Make sure that the newly-installed fan aligns horizontally with other
correctly-seated fans for proper installation.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 101.
Installing the optional dual-port network adapter
You can purchase one of the following dual-port network adapters to add two
additional network ports in the server. To order a dual-port network adapter option,
contact your IBM marketing representative or authorized reseller.
Table 12. Supported dual-port network adapters on the network connector
Dual-port network adapter
Option
part
number
FRU part
number Remark
Mellanox ConnectX-3 dual-port
QDR/FDR10 mezz card
90Y6338 90Y4956
Qlogic dual-port 10GbE SFP+
Embedded VFA
90Y6454 90Y5099 Two microprocessors
installed required.
Emulex dual-port 10GbE SFP+
Embedded VFA III
90Y6456 90Y5100
Dual-port FDR embedded adapter 00D4143 90Y6606
Chapter 2. Installing optional devices 95
To Next Page
Loading...
