8. Pull existing filler panels out of the server. Keep them in a safe place.
9. Install the hard disk drives.
10. Install the filler panels that come with the SAS/SATA 4 Pac HDD option into
empty drive bays.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 101.
Installing a second microprocessor and heat sink
The following notes describe the type of microprocessor that the server supports
and other information that you must consider when you install a microprocessor and
heat sink:
v Microprocessors are to be installed only by trained technicians.
Important: Always use the microprocessor installation tool to install a
microprocessor. Failing to use the microprocessor installation tool may damage
Chapter 2. Installing optional devices 79
To Next Page
Loading...
