System-board optional devices connectors
The following illustration shows the connectors on the system board for
user-installable options.
Installation guidelines
Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the system to halt, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when removing or installing a hot-swap
device.
Before you install optional devices, read the following information:
v Make sure that the devices that you are installing are supported. For a list of
supported optional devices for the server, see http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us/.
v Read the safety information that begins on page vii and the guidelines in
“Working inside the server with the power on” on page 40, and “Handling
static-sensitive devices” on page 40. This information will help you work safely.
v When you install your new server, take the opportunity to download and apply
the most recent firmware updates. This step will help to ensure that any known
issues are addressed and that your server is ready to function at maximum levels
of performance. To download firmware updates for your server, go to
http://www.ibm.com/support/fixcentral/.
38 IBM System x3550 M4 Type 7914: Installation and User’s Guide
To Next Page
Loading...
Need help?
General
