Note: When you restart the server, you are prompted to import the existing
RAID configuration to the new ServeRAID adapter.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 101.
Installing an optional ServeRAID adapter memory module
To install an optional ServeRAID adapter memory module, complete the following
steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 38.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the cover” on page 50).
4. Align the memory module with the connector on the ServeRAID adapter and
push it into the connector until it is firmly seated.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 101.
Installing the DVD drive cable
To install the DVD drive cable, complete the following steps:
Chapter 2. Installing optional devices 75
To Next Page
Loading...
