4. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
5. Install the hard disk drive in the drive bay:
a. Grasp the black drive handle and slide the blue release latch to the right
and align the drive assembly with the guide rails in the bay.
b. Gently push the drive into the bay until the drive stops.
6. Reinstall the drive bay filler panel that you removed earlier.
7. If you are installing additional simple-swap hard disk drives, do so now.
IDs for 2.5-inch simple-swap hard disk drives
The simple-swap-drive ID that is assigned to each drive is printed on the front of
the server. The following illustration shows the location of the IDs of the hard disk
drives. The ID numbers and the drive bay numbers are the same.
IDs for 3.5-inch simple-swap hard disk drives
The simple-swap-drive ID that is assigned to each drive is printed on the front of
the server. The following illustration shows the location of the IDs of the
simple-swap hard disk drives. The ID numbers and the drive bay numbers are the
same.
Chapter 2. Installing optional devices 55
To Next Page
Need help?
General
